Product informationIncluded in this listing is an RPi camshaft kit containing a Piper camshaft, standard timing chain set, OEM tappets and a set of high quality gaskets required to complete the job (water pump gasket now included) as well as full lifetime RPi telephone assistance should you need any help with installation. The kit here is suitable for any Rover V8 engine with a distributor and is the very same kit that we at RPi would use in our own engines so you can be sure of excellent quality in every part.
- High quality Piper camshaft - the only make of camshaft we'll use in our own engines.
- Standard timing chain set suitable for serp or pre-serp applications with a distributor (NOT Gems or Thor)
- OEM hydraulic tappets - the only type suitable for the Rover V8
- Cam kits for other engines are available - please enquire
Which cam best suits my needs?
Like the name suggests, this camshaft gives torque at the bottom to mid rev range, making it the perfect choice for four wheel drive applications such as Land Rovers and Range Rovers (especially if used for towing), as well as heavier saloons such as the Rover P5, P6 and SD1 which are still on standard heads
We now offer the Kent 180 camshaft as an option on our camshaft kits for earlier Rover V8 engines with distributor driven ignition systems. The Kent H180 sits between the Piper Torquemax and Piper 270 in terms of driving characteristics, and is a great choice when you can't quite decide between the two. We have also found it great with Hotwire EFi systems with Lambda loop enabled, where the Piper 270 camshaft might give a slightly lumpy idle.
A power increase in the mid rev range with a good increase in usable torque to boot, the Piper 270 is great for light 2wd cars in standard form such as MG B's and Morgans, or heavier saloons and Land Rovers which have been upgraded to stage 1 heads or beyond.
The 270i camshaft has similar characteristics to the 270 detailed above, however the profile is altered slightly to suit a Rover V8 engine fuelled by an injection system, which require more intake vacuum than a carburettor setup to get the correct air/fuel mixture at low engine RPM.
More power at the top of the rev range, while still keeping a smooth idle and driveability at low revs and low speeds and no noticeable loss of torque. Stage 1 or above cylinder heads and ECU chipping are especially recommended when using the 285 camshaft
- Shim kits for setting tapped pre-load are available and essential for all work involving camshaft, valves or rocker assemblies
- Never re-use your original tappets - doing so will cause accelerated wear of the camshaft
- Timing chains are normally badly stretched and will always need replacing
- Push rods are low-cost and should be replaced if at all worn
- Rockers and rocker shafts should be inspected for signs of wear or breakage